Changing The Digital Security Code; Installing The Holster - Uniden ELT 560 SERIES Owner's Manual

UP742.book Page 15 Tuesday, November 30, 2004 2:42 PM

Changing the Digital Security Code

The digital security code is an identification code used to connect the handset and
the base unit. Normally, setting the code is not necessary. In the rare situation that
you suspect another cordless telephone is using the same security code, you can
change the code. To change the digital security code:
1. Perform the "System Reset" options ("De-register the Handset" and "Replacing
the Base Setting") for all the handsets you have (see page 66).
2. Re-register each handset by following the steps on page 13.

Installing the Holster

- Line up the groove on the back of the handset with the groove on
the holster. It fits in the holster only one way.
- Slide the phone into the holster.
- Use the spring clip to attach the holster to your belt or pocket.
[ 1 5 ] C h a ng i ng t h e D i g it a l S e c ur it y C od e
note
You must remove the
holster to charge the
handset.
w w w . u n i d e n . c o m