Additional Information; Changing The Digital Security Code; Find Handset; Installing The Beltclip - Uniden DSS7815 Owner's Manual

Changing the Digital Security Code

The digital security code is an identification code used to connect the handset and the base
unit. Normally, setting the code is not necessary. In the rare situation that you suspect
another cordless telephone is using the same security code, you can change the code. To
change the digital security code:
! If the battery pack
1) De-register all the handsets you have (see "De-register the handset" on page 26).
is completely
2) Register the handsets by following step 2-3 in "Registering the handset" on page 15.
drained, the
handset will not

Find Handset

beep when
To locate the handset, press
paging.
All registered handsets beep for 60 seconds, and
To cancel paging, press any key on the handset or

Installing the Beltclip

To attach the beltclip
Insert the beltclip into the holes on each side of the handset.
Press down until it clicks.
To remove the beltclip
Pull either side of the beltclip to release the tabs from the holes.

Headset Installation

Your phone can be used with an optional headset. To use this
feature, insert the headset plug into the headset pack. Your phone is
ready for hands-free conversations. (Headset can be purchased
from a retailer or by visiting the web site. See page 56.)
find handset on the base when the phone is in standby mode.
Paging
[53]
appears on the handset display.
find handset on the base.