Additional Information; Changing The Digital Security Code - Uniden EXI2970 Series Manual

EXI2970 ENG-0719 7/18/01 19:51

Changing the Digital Security Code

The digital security code is an identification code used to connect the handset
and the base unit. Normally, setting the code is not necessary.
The first time you charge your handset, the security code is automatically set. (See
"About the digital security code", page 4.)
In the rare situation that you suspect another cordless telephone is using the same
If the handset battery
security code, you can change the code.
pack is completely
discharged or the
1) Remove the handset from the base unit. Press and hold
battery pack is removed,
the digital security code
2) The handset begins emitting a paging sound. While holding page/find for at
will be lost. If this
happens, a new security
code is set automatically
next time the battery
pack is charged.
[ 34 ] A D D I T I O N A L I N F O R M A T I O N
Page 34
least 3 seconds, place the handset on the base unit. The paging sound stops.
Leave the handset on the base for more than 5 seconds or until the status LED
stops flashing. A new random security code is set.
page/find on the base.