Display (Some Models); Phase / Warning Leds - Electrolux Washing machine Service Manual

4.9 Display (some models)

The display shows the following information:
Three flashing hyphens, when a programme is cancelled by pressing the SKIP/RESET button. The
hyphens will also be displayed when the ON/OFF button is pressed to switch the appliance on, but only
if the cycle selected previously has been cancelled.
The duration of the washing programme is displayed when the programme has been selected. This
time corresponds to the time necessary for the maximum wash load for each programme. When the
programme is started, the time is decremented (updated) at intervals of one minute.
Rinse hold: the appliance stops with water in the tub at the end of programmes for which the RINSE
HOLD option has been selected; the display shows a zero (fixed).
End of cycle indicated by a zero (flashing) and, at the same time, the door pilot lamp switches off. The
zero re-appears when the appliance is switched on again, if the previous programme has not been
cancelled.
Delayed start, which is selected using the DELAYED START button. The countdown starts when the
START/PAUSE button is pressed, and is decremented at intervals of one hour. During the last 2 hours
the countdown decrements at intervals of 30 minutes.
An alarm code indicates a machine malfunction.

4.10 Phase / warning LEDs

The LEDs indicate different information according to the type of
configuration; the End-of-cycle Led is featured in all models.
Type of LED
Lights during selection mode if the programme includes the pre-wash phase, and during
Pre-wash
the execution of the pre-wash.
Lights during selection mode if the programme includes the wash phase, and during the
Wash
execution of the wash.
Lights during selection mode if the programme includes the pre-wash or wash phases, and
Pre-wash/Wash
during the execution of these phases.
Lights during selection mode if the programme includes rinse phases, and during the
Rinse
execution of the rinse.
Lights during selection mode if the programme includes the spin phase, and during the
Spin
execution of the spin.
Lights during selection mode if the programme includes the drain phase, and during the
Drain
execution of the drain
Lights when this option has been memorized (if featured by the cycle) and during the
Extra rinse
execution of the rinse.
Lights if the programme includes the rinse-hold option and at the end of the cycle, when
Rinse hold
the appliance stops with water in the tub.
Current cycle Lights during execution of the cycle
End of cycle Lights when the programme has been completed; also used to display alarm conditions
Blocked filter Lights at the end of the cycle if the drain filter is blocked.
Overdosing Lights at the end of the cycle if a detergent overdosing alarm of occurs.
ON/OFF Lights when the appliance is switched on
Door
Lights when the display shows the time-to-end
Time to end
SOI/DT 2005-07 dmm
Lights when the door is locked by the interlock.
Switches off when the door is released.
Flashes when the door is about to release (especially in models with safety device
with PTC)
Functions
14/59 599 37 22 15