Pushbuttons - Leds And Lcd Display - Electrolux TC2 Service Manual

Press button P2 in sequence to choose one of the three levels. The corresponding LED will light up to confirm
the selection.
The different washing options such as: Pre-wash, Economy, etc. are set compulsorily as a programme.
3.2.6 Pushbuttons – LEDs and LCD display
The functions of each button are defined by the configuration of the appliance.
•
Button no. 1: this button is related to LEDs (L1÷L5). Pressing it
sequentially the spin speed varies from max., to no spin or rinse hold.
•
Button no. 2: this button is configurable and is related to LEDs
(L6÷L8). (In some appliances it is connected to the "Time manager")
•
Button no. 3: this button is configurable and is related to LED (L14); it
performs the super rinse function.
•
Button no. 4: this button is configurable and has the function of
START/PAUSE (inside there are two LEDs, one red that flashes in
the event of an alarm and one green that flashes when the appliance
is in pause mode or in combination with the red one to indicate the
alarm code).
•
Button no. 5: this button is configurable and has the function of
DELAYED START. During the programme selection phase, a delayed
start can be selected, from 30' to 20 hours (30'
3h... 20h 0h) and the time is shown on the LCD display.
During the last hour, the time decreases minute by minute.
In the washer-dryers, push this button to set the drying time
displayed on the LCD display. Each time it is pressed, the time
increases by five minutes (from a minimum of 10 minutes to a
maximum of 130 minutes)
SOI/DT 2010-03 dmm
L8 Daily
L7 Light
L6 Super Quick
60'
10/78
90' 2h
599 72 84-41