Table of Contents
Advertisement
8. Installation conditions
Correct installation in accordance with the following instructions ensures trouble-free operation of the device.
The device must not be exposed to large temperature differences during installation,
otherwise there is a risk of condensation forming inside the device. This can lead to a failure
of the electronics.
•
Visual checks of the device at the installation site should be possible.
•
The installation site must allow for simple assembly and disassembly of the device for
maintenance and inspection purposes.
•
The device must be installed exactly in the horizontal position to ensure that the water level is the
same above ALL ultrasonic transducers.
•
Automatic drainage of the fluid tank and automatic flushing of the demineralised water pipeline
require that a free discharge exists in accordance with DIN 1988-100.
•
The humidity sensor must be positioned in such a way that it is located in the area of the
humidifier, but that direct influence by the aerosol flow of air is excluded.
•
The stainless steel outlet pipes for the aerosol mist have a diameter of 40 mm and are located so
far away from each other that it is possible to connect commercially HT pipes with integrated lip
seals. The extensive delivery range of HT pipes provides cost-favourable, fast and highly flexible
aerosol guidance; so it is also possible to combine aerosol outputs.
Do not use any greasy lubricants for the installation of the aerosol pipes and tubes, because
that would change the surface tension of the water and nebulisation would no longer be
possible!
The interior areas of the device should always be protected against pollution! (Air filter boxes
see optional accessories)
[MBA_UB-1...4-CT_3.1_EN] Rev.: 02/2022 Translation of the original instructions
No liability accepted for translation or printing errors. Subject to changes in dimensions, weights and other technical data.
All rights reserved. Modifications, reprints and photomechanical reproduction, even in extract from, require the express perm ission of BOGA GmbH, Werkstraße 16, D-59494 Soest.
13
Advertisement
Table of Contents
