Huawei UPS5000-E-180 kVA User Manual page 27

UPS5000-E-180 kVA
User Manual (Integrated UPS, 30 kVA Power
Modules)
●
●
●
●
●
●
●
●
●
●
Working at Heights
●
●
●
Issue 05 (2024-01-30)
Wear personal protective gears such as protective gloves and shoes when
manually moving the equipment.
To move an object by hand, approach the object, squat down, and then lift
the object slowly and stably by the force of the legs instead of your back. Do
not lift it suddenly or turn or twist your body.
Move or lift the equipment by holding its handles or lower edges. Do not hold
the handles of modules that are installed in the equipment.
Slowly lift a heavy object above your waist. Place the object on a workbench
that is half-waist high or any other appropriate place, adjust the positions of
your palms, and then lift it.
Move a heavy object stably with balanced force at an even and low speed. Put
down the object stably and slowly to prevent any collision or drop that may
cause scratches on the surface of the equipment or damage to the
components and cables.
When moving a heavy object, be aware of the workbench, slope, staircase,
and slippery places. When moving a heavy object through a door, ensure that
the door is wide enough to move the object and avoid bumping or injury.
When transferring a heavy object, move your feet instead of twisting your
waist. When lifting and transferring a heavy object, ensure that your feet
point to the target direction of movement.
When transporting the equipment using a forklift truck, ensure that the forks
are properly positioned so that the equipment does not topple. Before moving
the equipment, secure it to the forklift truck using ropes. When moving the
equipment, assign dedicated personnel to take care of it.
Choose sea or roads in good conditions for transportation. Do not transport
batteries by railway or air. Avoid tilt or jolt during transportation.
When transporting a cabinet, ensure that its tilt angle meets the requirements
shown in the figure. The tilt angle α of a cabinet with packaging shall be less
than or equal to 15°. After the cabinet is unpacked, its tilt angle α shall be
less than or equal to 10°.
Any operations performed 2 meters or higher above the ground must be
supervised properly.
Only trained and qualified personnel are allowed to work at heights.
Do not work at heights when steel pipes are wet or other risky situations
exist. After the preceding conditions no longer exist, the safety owner and
Copyright © Huawei Digital Power Technologies Co., Ltd.
1 Safety Information
19