Network Connection And Setup - Konica Minolta bizhub pro 950 Installation Manual

3. Loosen the Monitor adjusting knob/1 and
determine the vertical position of the moni-
tor.
Tighten the Monitor adjusting knob/1 to
secure it.
XI. Network connection and setup
1. Connect the network cable.
There are two kinds of network functions: on the
Main body side (Machine NIC) and Printer con-
troller side (Controller NIC), and there are two
connector slots (RJ-45).
Depending on the user's purpose, connect the
network cable to either or both slots. (See the
table below for functions of NIC.)
Machine NIC
(RJ-45)
Note:
• Use category 5 or 5E network cables.
Function Machine NIC Controller NIC
Extension for
maintenance
(Internet ISW, etc.)
Scanner function
Printer function
Step
Monitor adjusting knob/1
Controller NIC
(RJ-45)
A0Y5IXC027CA
O
O
O
[LED]
Both the Controller NIC (outside) and the Machine
NIC (inside) have two LEDs (LED1 and LED2),
each of which represent the following conditions.
LED 1 (top): Displays communication speed
Orange (1Gbps)
Green (100Mbps)
OFF(10Mbps)
LED 2 (bottom): Displays the link state
Lighting (Network is connected)
Blinking (Data transfer state)
OFF (Network is disconnected)
2. IP address allocation
Note:
• Usually a dedicated administrator handles the
network and PC environment at the user end.
When conducting the following setup proce-
dure, always consult with proper personnel, get
approval, and operate under that person's
supervision.
• The Controller NIC has the DHCP function,
however the initial setting is OFF, so make sure
to implement network settings.
1. Press the [Utility/Counter] button.
2. Touch the "Administrator Setting" key.
3. Touch the "Network Setting" key.
4.
Machine NIC setting
1. Touch the "Machine NIC Setting" key
to set the following items. After set-
tings are done, touch the "OK" key.
• IP Address (IP address of the Main
body)
• Subnet Mask (subnet mask for the
network)
• Gateway Address (IP address of the
default gateway)
Controller NIC setting
1. Touch the "Controller NIC Setting"
key.
2. Touch the "TCP/IP Setting" key and
"Next" key to set the following items.
After settings are done, touch the
"OK" key.
• IP Address (IP address of the con-
troller)
• Subnet Mask (Subnet Mask for the
network)
• Default Gateway (IP address of the
default gateway)
E-16
Step