Administrative Requirements Prior To Mfp Http Setup; Mfp Specific Requirements; Setting Mfp Date/Time Settings - Konica Minolta bizhub PRO 1200 Setup Instructions

A. Administrative Requirements Prior to MFP HTTP Setup
The MFP's HTTP settings and Server addresses MUST be obtained prior to setting up the MFP for
HTTP Communication.
B. MFP Specific Requirements
The technician performing the HTTP setup must have the following information from the vCare
administrator before visiting the customer:
1. Device ID: The Device ID for MFP must match the 13 digit ID configured on CSRC Server. The
Device ID is the serial number for the MFP. This setting is hard-coded in the bizhub PRO 1200/1200P
and 1051 vCare/CSRC settings.
2. Center ID: This ID is used by the vCare/CSRC Communication Server.
3. WEB/DAV Server IP Address: The IP address for the WEB/DAV Server.
4. HTTP Port: Typically 80, unless otherwise indicated.
5. Service Engineer's ID number: The SE ID is a seven-digit number. It should be unique to the
technician servicing the machine. Enter leading zeros if required; e.g. 0123456. If no numeric ID
assigned, simply use: 1234567.
C. Setting MFP Date/Time Settings
1. Press the Utility / Counter button on the MFP
2. Select [Administrator Setting].
Enter Administrator password, as required. (Default = 12345678)
Konica Minolta bizhub PRO 1200/1200P 1051
bizhub vCare HTTP Setup Guide
Page 2 of 22