Table of Contents
Advertisement
Installation Instructions
STEP 11 |CONNECT WATER SUPPLY
\
House
Water
Supply
Refrigerator
/
Water Supply
* Locate and bring tubing to the front of the cabinet.
¢ Turn the water on to flush debris from line. Run about
a quart of water through tubing into a bucket, then
shut off water.
Copper Tubing:
Slip a 1/4" nut and ferrule (provided) over both ends
of the copper tubing. Insert tube into the union fitting
on the unit and tighten nut to union.
® Turn on the water to check for leaks.
GE SmartConnect™ Tubing:
* Insert the molded end of the tubing into the
refrigerator connection. Tighten the compression nut
until it is just hand tight.
¢ Tighten one additional turn with a wrench.
Overtightening can cause leaks!
* Turn on the water to check for leaks.
Note: Make sure excess tubing length does not
interfere with drawer closing or toekick installation.
16
STEP 12 |CONNECT POWER
* Check to be sure the power cord is plugged into the
receptacle.
Sb
<l
{
a
|S
o E
Lo
4:
|
Electrical
|
Outlet
Master
Light Switch
* Check to make sure power to refrigerator is on by
opening refrigerator door to see if interior lights are
on.
e The temperature controls are preset at 37°F
for the fresh food section and O°F for the freezer.
e Allow 24 hours to stabilize before making
adjustments.
STEP 13 |START ICEMAKER
e Flip the switch to | (ON). The icemaker will begin
operation automatically.
¢ Be sure nothing interferes with the sweep of
the feeler arm.
¢ Discard the first full bucket of ice cubes.
¢ To turn the icemaker off, set the switch to O (OFF).
Advertisement
Table of Contents
