Table of Contents
Advertisement
STEP 18 CONNECT WATER SUPPLY
(FREEZER MODELS ONLY)
House
Water Supply
• Locate and bring the tubing to the front of the cabinet.
• Turn the water on to flush debris from the line. Run
about a quart of water through the tubing into a
bucket, then shut off the water.
Copper Tubing:
• Slip a 1/4" nut and ferrule (provided) over both ends
of the copper tubing. Insert the tube into the union
fitting on the unit and tighten the nut to the union.
• Turn on the water to check for leaks.
GE SmartConnect
Tubing:
™
NOTE: The only GE-approved plastic tubing is supplied
in the GE SmartConnect ™ Refrigerator Tubing kits. Do
not use any other plastic water supply line because the
line is under pressure at all times. Other types of plastic
may crack or rupture with age and cause water dam-
age to your home.
• Insert the molded end of the tubing into the appliance
or freezer connection. Tighten the compression nut
until it is just hand-tight.
• Tighten one additional turn with a wrench.
Overtightening can cause leaks!
• Turn on the water to check for leaks.
NOTE: Make sure excess tubing length does not
interfere with the toekick installation.
Installation Instructions
Freezer
Water Supply
STEP 19 START ICEMAKER
(FREEZER MODELS ONLY)
Power
Switch
• Slide the switch to ON. The icemaker will begin
operation automatically.
• Be sure nothing interferes with the sweep of the feeler
arm.
• Discard the first full bucket of ice cubes.
• To turn the icemaker off, slide the switch to OFF.
STEP 20 INSTALL TOEKICK
• Locate the supplied toekick (shipped taped to
the side of the appliance). Install the toekick assembly
with the 2 screws provided, adjust to the desired
height and tighten the screws.
IMPORTANT: A custom toekick can be installed to
match or complement the surrounding cabinetry but
can NOT cover the horizontal vent slots of the factory
toe kick.
29
Icemaker
Feeler Arm
Advertisement
Table of Contents
