Table of Contents
Advertisement
Installation
Instructions
STEP 10] INSTALL DISPENSER
TRIM
Skip this step is you are installing a stainless
steel wrapped or a non-dispenser refrigerator.
There
are
two
dispenser
trims
shipped
with
your
refligeratoL
Select
the
appropriate
trim
for your
applicad
on.
Overlay
I Panel
I
mm
Compare the dispenser trims. Note that the inside
depth of the frames are different, Choosethe trim
with less depth for framed panels, choose the
deeper one for overlay panels.
Dispenser
trim fit over the custom
panel
depends
on
correct
panel
thickness.
See pages
7 and 8 for panel
construction
information.
• Press and snap
the dispenser
trim
into the dis-
penser
recess
on the refrigerator
dooL
If an excessive gap exists around
the dispenser
trim
or if the panel fits loosely in the door flame, foam
tape may be applied
to help improve the fit. Remove
the trim and panel and apply foam tape to the door
around
the dispenser
and in the corners.
STEP 11 CONNECT WATER SUPPLY
Check
to be sure that refrigerator
power
cord is not
plugged
into the wall outlet.
11
I
---.
,\
Refrigerator
House
"-\.Water Supply
Water Supply//
• I,ocate
and bring
tubing
to the flont
of the cabinet.
• Turn
the water
on to flush
debris
from
line. Run
about
a quart
of water
through
robing
into a bucket,
then shut-off
wateL
Copper Tubing:
• Slip a 1/4" nut and ferrule
(provided)
over both
ends of the copper
tubing. Insert robe into the
union fitting on the unit and tighten
nut to union.
• Turn on the water to check for leaks.
GE SmartConnect
TM
Tubing:
• Insert the molded
end of the robing into the
refligerator
connection.
Tighten
the compression
ntlt
until it is just hand tight.
• Tighten one additional
turn with a wrench.
Overdghtening
can cause leaks!
• Turn on the water to check for leaks.
Note: Make sure excess tubing length does not
interfere
with toekick installation.
17
Advertisement
Table of Contents
