Table of Contents
Advertisement
Design Guide
THE INSTALLATION SPACE
35-1/2"
It—Finished Width —*
The finished
25/16"
Wall View
cutout width
oy
must be
ee:
.
35-1/2"
O° \\ Electrical
1
Area
85"
"F-24" Cutout Depth
75" From
Finished
Floor to Bottom
Opening
Water Supply
of Electrical Area
f/o\
pty
.
Water And Electrical Locations
Electrical and water supply must be located
The cutout depth must be 24"
as shown.
The refrigerator will project forward, slightly beyond
adjacent cabinetry, depending on your installation.
Allow minirnum 1/8" air gap between case back & wall.
Cutout depth beneath a soffit:
When installed beneath a soffit, the soffit cannot exceed
the 24" installation depth shown. The top case trim
overlaps the bottom of the soffit.
Additional Specifications
A115 volt 60Hz., 15 or 20 amp power supply is required.
An individual properly grounded branch circuit or circuit
breaker is recommended. Install
a properly grounded 3-prong electrical receptacle
recessed into the back wall. Electrical must be located
on rear wall as shown.
Note: GFI (ground fault interrupter} is not recommended.
* Water line can enter the opening through the floor
or back wall. Route GE SrnartConnect™ kit or 1/4" 0.D.
copper tubing between the cold water line and the
water connection location. The tubing should be
long enough to extend to the front of the refrigerator.
Installation of an easily accessible shut-off valve in the
water line is required.
DIMENSIONS AND CLEARANCES
35"
25-3/8" Framed Models
Case Width
25-3/4" Stainless Steel Models
r— Case Depth
>|
* Shipping height. The
refrigerator can be
adjusted to fit into a
*84" From
cutout that is 83-1/2"
oer ome
min. to 84-1/2" max.
height. Note that the top
case trim at the front is
1/2" higher and will
overlap upper cabinetry
or soffit. Use leveling
-t. 36" Frame to
legs and wheels for a
i
-
+
.
a
.
Frame Width =
maximum 1" height
Depth including Handles:
adjustment.
27" Framed Models
27-13/16" Stainless Steel Models
28-5/8" Professional Style Models
Product Clearances
These refrigerators are equipped with a 2-position coor
stop. The factory set 130° door swing can be adjusted to
90° if clearance to adjacent cabinets or walls is restricted.
12-1/8"
12-1/8"
Min. to
Min. to
Wall
Wall
z
|
23-7/8"
Behind
Frame
ft
+
——
I
af
fo?
ee
LS
I
a
I
» Stainless &
va
7
PN
Sy
90°
By
90°
18-1/8
Pro Madeis)
a
wd
van
| ee yen
"130
Bo
NS
|
UN,
| |18-3/16" (frames
*
;
mh
Lhd
*4" Stainless and
AA
Framed Models.
«min. Distance
5" Pro Series
to Wall
Allow 12-1/8" minimum clearance for a full 130° door
swing.
For a 90° door swing, allow 4" min. clearance to a wall,
for framed and stainless steel rnodels. Allow 5" min.
clearance for professional style models. If the 90° door
stop position is used, pan access is maintained, but pan
removal is restricted.
See illustrations pages 4 and 5 to determine door swing
interaction with adjacent cabinets or countertops.
Advertisement
Table of Contents
