Step 2A, Ro Water Line; Step 3 Connect Water Supply; Step 4 Connect Power; Step 5 Move Refrigerator Into Position - GE ZFSB23D SS Installation Instructions Manual

Step 2A WATER LINE
INSTALLATION WITH A
REVERSE OSMOSIS SYSTEM
Skip this step when not using RO System
IMPORTANT:
When connecting to a GE reverse osmosis water
system to your refrigerator, the GE RVKit must be
used. For other reverse osmosis water systems, follow
the manufacturer's recommendations.
If the water supply to the refrigerator is from a
Reverse Osmosis Water System, use the refrigerator's
filter bypass plug. Using the refrigerator's water
filtration cartridge with the RO filter can result in
hollow ice cubes and slower water flow from the water
dispenser.
Turn left to remove
Installation Instructions
Turn right to install bypass plug

STEP 3 CONNECT WATER SUPPLY

Check to be sure that refrigerator power cord is not
plugged into the wall outlet.
Tubing Clamp
1/4"
Compression Nut
Ferrule
(sleeve)
Refrigerator Connection
If you are using copper tubing:
• Place compression nut and ferrule (sleeve) onto
the end of the tubing coming from the house
water supply.
• Insert the end of the copper tubing into the
refrigerator connection at the back of the refrig-
erator, as far as possible. Hold the tubing in place
and tighten the fitting.
If you are using GE SmartConnect™ tubing:
• Insert the molded end of the tubing into the
refrigerator connection, at the back of the refrig-
erator, and tighten the compression nut until it is
hand tight.
• Then tighten one additional turn with a wrench.
Overtightening may cause leaks.
• Fasten the tubing into the clamp provided to hold
it in position. You may need to pry open the clamp.
• Turn on the water at the shut-off valve to check for
leaks.

STEP 4 CONNECT POWER

• Connect refrigerator power cord plug to a properly
grounded receptacle.
• Check to make sure power to refrigerator is on by
opening refrigerator door to see if interior lights
are on.
STEP 5 MOVE REFRIGERATOR
INTO POSITION
• Remove outside protective wrapping.
• Move the refrigerator into final installation position.
• Remove door spacer and all inside packaging.
7
1/4" Tubing
SmartConnect™ Tubing