Advertisement
MIG Operation - EASY SET
Once you have selected required MIG mode you will see a screen as below.
This is the MIG manual screen.
Now press in the EASY SET button and the following screen will be shown
Use the middle knob to cycle through settings, when a setting is highlighted in red, use the left control
knob to change setting.
Wire diameter being used 0.6, 0.8,1 .0mm & Material thickness in mm
2/4T Trigger operation & Torch Standard / Spool gun torch
Once you have selected the required wire diameter and material thickness, the recommended wire feed
speed and welding voltage is shown, you can trim both these settings to suit personal travel speed etc.
To trim M/Min use middle knob to highlight M/Min in red, then adjust using left knob.
To trim Voltage, use right side control knob.
Spool gun operation - when using spool gun, the knob on gun itself trims / controls the wire feed speed.
19
Advertisement
