Advertisement
R-Tech Easy mode takes the guesswork out of TIG welding. You normally had to set the welding
amperage before beginning to weld on manual welders, we have done this for you.
You simply select the following from an easy to understand screen.
You can then trim the welding amperage to suit your personal travel speed etc.
TO ENTER EASY MODE - PRESS EASY BUTTON ON FRONT PANEL - EASY HOME SCREEN WILL SHOW
In manual mode your have full control off all weld settings
DC TIG EASY MODE
Tungsten size being used
Material thickness
The machine will set the required welding amperage.
DC TIG MANUAL MODE
Welding amperage
HF or Lift start
2T/4T/4TS/2T+F/4T+F trigger modes
Pre flow gas time
Up-slope time
Down-slope time
Post flow gas time
You can also adjust advanced features as below
Pulse mode on/off
Pulse time %
Pulse amps %
Pulse Frequency Hz
Spot / Tack mode
Spot / Tack time
Start amps
End amps
Stitch time
17
Advertisement
