Advertisement
R-Tech Easy mode takes the guesswork out of MIG welding. You normally had to enter wire feed speed
and welding voltage before beginning to weld on manual welders, we have done this for you.
You simply select the following from easy to understand screen.
You can then trim the wire speed / voltage to suit your personal travel speed etc.
TO ENTER EASY MODE - PRESS EASY BUTTON ON FRONT PANEL - EASY HOME SCREEN WILL SHOW
Controls and settings
The MTS251-TFT features 6 main operating modes
MIG in EASY mode
MIG in Manual mode
DC TIG in EASY mode
DC TIG in Manual mode
MMA (STICK) in EASY mode
MMA (STICK) in Manual mode
MIG EASY MODE
Wire diameter being used
Material thickness
The machine will set wire feed and welding voltage.
MIG MANUAL MODE
In manual mode your have full control off all weld settings
Wire feed speed
Welding voltage
2/4T Trigger operation
Spool gun on/off
You can also adjust advanced features as below
Start / end amps
Pre and post flow gas
Up-slope and downslope
Spot and stich weld timer
15
Advertisement
