Advertisement
DC TIG EASY MODE
Once you have selected DC TIG mode, Press EASY SET and you will see a screen as below.
R-Tech Easy mode takes the guesswork out of TIG welding. You normally had to enter desired amperage to
weld on manual welders, we have done this for you.
You simply select the following from easy to understand screen.
Trigger operation 2T/4T/PEDAL/2T+F/4T+F
Start type - HF/Lift
Tungsten size
Work thickness
Options are
1.6mm Tungsten = 1.0, 1.2, 1.5, 2, 3mm
2.4mm Tungsten = 1.0, 1.2, 1.5, 2, 3, 4, 5, 6, 8mm
Simply turn middle knob until selection is highlighted in RED, then use left knob to adjust as required.
The machine will set main amperage power required. You can trim + / - 10A to suit personal style.
Trim amperage by highlighting A in RED, then use left knob to trim.
To exit to function select menu, highlight home in RED then press middle knob.
To go to TIG manual screen, press the EASY SET button so LED is off.
22
Advertisement
