Table of Contents
Advertisement
262
Emergency
situations
Front towing loop
Fig. 180 Right front bumper: remov ing the
cover
Fig. 181 Right front bumper: towing loop installed
The threaded opening for the towing loop is
located behind a cover on the right side of the
front bumper.
• Remov e the towing loop from the vehicle
tool kit ¢
page
247.
• Press inward on the upper le~ side of the
cap to remove it from the bumper
¢ fig . 180.
• Insert the towing loop in the threaded open-
ing until it stops ¢ fig . 181 and tighten it
with a whee l wrench.
• After using, place the towing loop back in
the vehicle tool kit .
A
WARNING
If you do not screw the towing loop com-
pletely, it cou ld come out of the threaded
hole while the vehicle is being towed caus-
ing damage to the vehicle and possible se-
rious personal injury.
-
Rear towing loop
Fig. 18 2 Righ t rea r towing loop :
cover
Fig. 183 Right rea r towing loop: towing loop installed
The towing loop threaded opening is located
in the right of the rear bumper cover under a
cover.
• Remove the towing loop from the vehicle
tool kit ¢
page
247 .
• Press inward on the upper area -arrow- and
lift it upward from the lower area ¢ fig. 182.
• Insert the towing loop in the threaded open -
ing until it stops ¢ fig . 183 and tighten it
with a wheel wrench .
• After using, p lace the tow ing loop back in
the vehicle tool kit.
Depending on the model, the shape of the
cover can vary.
.&_
WARNING
If you do not screw the towing loop com-
pletely, it could come ou t of t he threaded
hole wh ile the vehicle is being towed caus-
ing damage to the vehicle and possible se-
rious personal injury.
-
Advertisement
Table of Contents
