Table of Contents
Advertisement
Switching on and off
Applies to vehicles: with Audi active lane assist
•
Fig. 81
Turn signal lever: butto n fo r act ive lane ass ist
Fig.
82 Windsh ield: camera window for act ive lane as -
s ist
.. Press the ~
fig . 81
button to switch the sys-
tem on and off. The .
or .
ind icator light
in the instr ument cluster turns on or off.
Indicator lights
•
Ready: The indicator light turns on when
the system is ready for use. The system can
now be operated .
•
Not Ready: The indica t or light turns on if
the system is switched on but is inoperable.
This may be due to the following reasons:
- There is no lane boundary line.
- The relevant lane marker lines are not de-
tected (for example, markings in a construc-
tion zone or because they are obstructed by
snow, dirt, water or light ing).
- The vehicle speed is below the activation
speed of approximately 40 mph (65 km/h)
(the speed may vary depending on your
country) .
- The lane is narrower than 8
ft
(2 .5 m) or
wider than 18
ft
(5.5 m).
- The curve is too narrow.
Audi
active
lane
assist
95
- The driver's hands are not on the steering
wheel.
a)
Tips
- Make sure the camera's field of view
~
fig. 82
is not obstructed by stickers or
other objects. For information on clean-
ing, see ¢ page
201 .
- Market-specific: I n certain countries: If
the system is switched on, it wi ll remain
operab le each time the ignition is switch-
ed on.
lane assist display in the instrument
cluster
Applies to vehicles: with Audi active lane assist
Fig.
83 Ins tr umen t cluster: monoc hrome d ispl ay
Fig. 84
Ins tr ume nt clust er: mult icolored disp lay
The lane assist display can be called up using
the buttons in the multifunction steering
wheel* ¢ page
27.
Monochrome display
Refer to
~
fig. 83
Advertisement
Table of Contents
