Table of Contents
Advertisement
07 CHARGING
7.2 Charging Instructions
WARNING - Read all the safety and general instructions. Failure
to observe the safety and general instructions may result in electric
shock, fire and/or serious injury.
•
Read and observe the safety warnings and directions contained in all
the eBike system operating instructions and in the operating instructions
of your eBike.
•
Carefully cover the charging socket with the cover after charging the
eBike to prevent dirt or water ingress.
•
Do not expose the charger to rain or wet conditions. If water enters a
charger, there is a risk of electric shock.
•
Only charge Li-ion batteries approved for Kynamic eBikes with
approved Kynamic chargers. The battery voltage must match the
battery charging voltage of the charger. Only charge rechargeable
batteries. Otherwise, there is a risk of fire or explosion.
•
Keep the charger clean. Dirt poses a risk of electric shock.
•
Always check the charger, cable and plug before use. Stop using the
charger if you discover any damage. Do not open the charger. Damaged
chargers, cables and plugs increase the risk of electric shock.
•
Do not operate the charger on an easily ignited surface (e.g. paper,
textiles, etc.) or in a flammable environment. There is a risk of fire due to
the charger heating up during operation.
•
Take care if you touch the charger while it is charging. Wear protective
gloves. The charger can get very hot, especially when the ambient
temperature is high.
•
The eBike battery may give off fumes if it becomes damaged or is
used incorrectly. Ensure the area is well ventilated and seek medical
attention should you experience any adverse effects. The fumes may
irritate the respiratory system.
•
Charger light warning. If the LED light on the charger does not light up,
this suggests there is a problem with the charger or battery. Please return
the bike and charger to your nearest Whyte retailer for diagnosis.
•
Do not leave batteries charging for more than 24 hours, if the charging
cannot be completed in 8 hours, contact your nearest Whyte retailer to
have a battery health check.
Charging the Battery
- Plug the charger into the outlet. Pay attention to the mains voltage. The
voltage of the power source must match the voltage specified on the rating
plate of the charger.
-Locate the eBike charge port and lift the cover. Plug the charger into the
socket. Illustration shown below may differ slightly from the actual conditions
depending on the equipment of your eBike.
33
Advertisement
Table of Contents
