Hub Motor; Product Information; Operation - Whyte KYNAMIC Quick Start Manual

Table of Contents

09 HUB MOTOR

Please observe the operating instructions of the control unit and, if necessary,

additional components from the system generation.

Notes on Cycling with Your eBike

When does the drive work? The drive assists you only when you are pedalling.

If you do not pedal, the assistance will not work. The drive power always

depends on the pedalling force and cadence you apply. With low force or

cadence, the support will be less than with high force or cadence. This applies

irrespective of the assistance level.

The drive automatically switches off at speeds over 25 km/h. When the speed

falls be low 25 km/h, the drive automatically becomes available again. An

exception applies to the walk assistance function, in which the eBike can be

pushed at low speed without pedalling. The pedals may rotate when the walk

assistance is in use.

You can also use the eBike as a normal bicycle without assistance at any time,

either by switching off the eBike or by setting the assistance level to OFF. The

same applies when the eBike battery is drained.

Interaction Between the Drive Unit and Gear-shifting

The gear shifting should be used with an eBike in the same way as with a

normal bicycle. Irrespective of the type of gear shifting, it is advisable that

you briefly reduce the pressure on the pedals when changing gear. This will

aid gear shifting and reduce wear on the powertrain. By selecting the correct

gear, you can increase your speed and range while applying the same amount

of force.

Read all the safety and general instructions. Failure to observe the

safety and general instructions may result in electric shock, fire and/

or serious injury.

INFO: The A-weighted emission sound pressure level at the driver

ears is less than 70 dB(A).

Table of Contents