Table of Contents
Advertisement
Disassembly Procedures
!
WARNING
Door Hinges
1. Remove oven door, see "Removal" procedure above.
2. Place oven door on a padded surface.
3. Remove screws securing outer door to inner oven
door, screws located on top and bottom.
4. Separate outer door from inner door, by pulling the
two pieces apart.
5. Remove screw securing door hinge to inner door
assembly.
6. Replace component and reverse procedure to
reassemble.
Broiler Element
1. Turn off gas and power supply to the cooktop.
2. Remove oven door, see "Oven Door" procedure.
3. Remove oven racks from the oven cavity.
4. Remove screws securing broil element protection
brackets.
5. Remove screws securing broil element to top of the
oven cavity.
6. Pull element forward into the oven cavity, lower front
portion of the element and continue to pull forward on
element until wire terminal ends are inside the oven
cavity.
7. Disconnect wire terminals from broil element and
remove for unit.
8. Replace component and reverse procedure to
reassemble.
Convection Assembly
1. Turn off gas and power supply to the cooktop.
2. Remove oven door, see "Oven Door" procedure.
3. Remove oven racks from the oven cavity.
4. Remove screws securing convection cover to
convection mounting bracket.
5. Remove screws securing convection mounting
bracket to oven cavity.
6. Pull convection assemble forward to gain access to
wire terminals on motor and element.
7. Disconnect and label wire terminals from motor and
element.
8. Remove convection assembly from unit.
9. Replace component and reverse procedure to
reassemble.
20
To avoid the risk of electrical shock, personal injury or
death; disconnect power to range and shut off gas
supply before following any disassembly procedure.
Bake Element
1. Turn off gas and power supply to the cooktop.
2. Remove oven door, see "Oven Door" procedure.
3. Remove oven racks from the oven cavity.
4. Remove screws securing bake element to rear of oven
cavity.
5. Pull element forward into the oven cavity, raise front
portion of the element and continue to pull forward on
element until wire terminal ends are inside the oven
cavity.
6. Disconnect wire terminals from broil element and
remove for unit.
7. Replace component and reverse procedure to
reassemble.
Cooling Fan
NOTE: This procedure requires removal of unit from
installation position.
1. Turn off gas and power supply to the cooktop.
2. Remove screws securing upper back panel to oven
chassis and remove panel.
3. Disconnect and label wire terminals from cooling fan
and infinite switch.
4. Remove screws securing cooling fan bracket to oven
chassis.
5. Remove screws securing cooling fan to cooling fan
bracket.
6. Replace component and reverse procedure to
reassemble.
Kick Plate
1. Loosen screws securing outer edge of kick plate,
located on the bottom of kick plate.
2. Pull kick plate forward and remove from unit.
3. Replace or reverse procedure to reassemble.
Side Panel(s)
NOTE: This procedure requires removal of unit from
installation position.
1. Release control panel cover, see "Control Panel"
procedure, steps 1 through 6.
2. Remove kick plate, see "Kick Plate" procedure.
3. Remove upper and lower back panels screws located
on the side panel that is being replaced.
4. Remove screws securing side panel to unit chassis.
Pull outward on bottom of side panel and lift upward
to release from unit.
5. Replace component and reverse procedure to
reassemble.
16026509
© 2005 Maytag Services
Advertisement
Table of Contents
