Table of Contents
Advertisement
Disassembly Procedures
!
WARNING
Removing and Replacing Unit
1. Turn off power to the oven at the circuit breaker.
NOTE: To avoid property damage, place a protective
covering on the floor.
2. Lift unit and pull forward out of the installation
position.
3. Disconnect or unplug the power cord leading from unit
to junction box or outlet depending on connection.
4. Turn off gas supply and disconnect from main gas
line.
5. Reinstall the oven using the installation instructions.
Knob Bezel(s)
1. Remove surface burner knobs from control panel, by
pulling knobs straight off.
2. Remove screws securing knob bezel to control panel.
3. Replace component and reverse procedures to
reassemble.
NOTE: Alignment may be required when installing bezel.
Control Panel and Indicator Light(s)
1. Turn off gas and power supply to the range.
2. Remove surface burner knobs from control panel, by
pulling knobs straight off.
3. Remove screws securing control panel to chassis,
located at the bottom outside corners of the control
panel.
4. Pull bottom portion of control panel outward to release
metal tabs securing panel.
5. Push bottom portion of control panel back against the
range.
6. Raise control panel upward to release from position.
7. Disconnect and label wire terminals from burner
indicator lights and oven light switch.
8. Push upward on oven indicator lights to release from
lens.
9. Push surface burner indicator lights and oven
indicator lens outward through the front of the control
panel.
10. Remove nut securing oven light switch to control
panel and remove oven indicator by pushing outward
through the front of the control panel.
11. Remove screws securing knob bezels to control
panel.
12. Replace component(s) and reverse procedure to
reassemble.
© 2005 Maytag Services
To avoid the risk of electrical shock, personal injury or
death; disconnect power to range and shut off gas
supply before following any disassembly procedure.
Surface Burner Micro Switch(es)
1. Turn off gas and power supply to the range.
2. Release control panel cover, see "Control Panel and
Indicator Light(s)" procedure, steps 1 through 6.
3. Disconnect and label wire terminals from micro switch
located on the burner valve stem.
4. Remove micro switch from burner valve stem, by
pulling switch off of burner valve stem.
5. Replace component and reverse procedure to
reassemble.
Surface Burner Valve(s)
1. Turn off gas and power supply to the cooktop.
2. Release control panel cover, see "Control Panel and
Indicator Light(s)" procedure, steps 1 through 6.
3. Remove micro switch from burner valve stem.
4. Disconnect venturi tube connected to surface valve
being replaced.
5. Remove bolt securing burner valve to manifold pipe.
6. Replace component and reverse procedure to
reassemble.
NOTE: When installing valve, perform gas leak test to
ensure valve will not leak and range operates
properly.
16026509
17
Advertisement
Table of Contents
