Maytag W10252706B Installation Instructions Manual
Maytag W10252706B Installation Instructions Manual

Maytag W10252706B Installation Instructions Manual

30" (76 cm) freestanding electric ranges

Advertisement

30" (76 CM) FREESTANDING ELECTRIC RANGES
IMPORTANT:
Save for local electrical inspector's use.
W10252706B
INSTALLATION INSTRUCTIONS

Table of Contents

RANGE SAFETY ................................................................................... 2
INSTALLATION REQUIREMENTS ...................................................... 3
Tools and Parts .................................................................................. 3
Location Requirements ...................................................................... 3
Electrical Requirements - U.S.A. Only ............................................... 4
INSTALLATION INSTRUCTIONS ........................................................ 6
Unpack Range.................................................................................... 6
Install Anti-Tip Bracket....................................................................... 6
Electrical Connection - U.S.A. Only ................................................... 7
Verify Anti-Tip Bracket Location ...................................................... 12
Level Range...................................................................................... 12
Storage Drawer ................................................................................ 12
Complete Installation ....................................................................... 13
Moving the Range ............................................................................ 14
ANTI-TIP BRACKET TEMPLATE ..................................................... 15

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the W10252706B and is the answer not in the manual?

Questions and answers

Summary of Contents for Maytag W10252706B

  • Page 1: Table Of Contents

    Electrical Connection - U.S.A. Only ... 7 Verify Anti-Tip Bracket Location ... 12 Level Range... 12 Storage Drawer ... 12 Complete Installation ... 13 Moving the Range ... 14 ANTI-TIP BRACKET TEMPLATE ... 15 IMPORTANT: Save for local electrical inspector's use. W10252706B Table of Contents...
  • Page 2: Range Safety

    All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed. A child or adult can tip the range and be killed. Connect anti-tip bracket to rear range foot.
  • Page 3: Installation Requirements

    Installations, ANSI A225.1/NFPA 501A or local codes. Mobile home installations require: When this range is installed in a mobile home, it must be secured to the floor during transit. Any method of securing the range is adequate as long as it conforms to the standards listed above.
  • Page 4: Electrical Requirements - U.s.a. Only

    E. 25" (63.5 cm) depth F. Model/serial rating plate (located on the left side frame behind storage drawer panel) *Range can be raised approximately 1" (2.5 cm) by adjusting the leveling legs. Cabinet Dimensions Cabinet opening dimensions shown are for 25" (64.0 cm) countertop depth, 24"...
  • Page 5 A UL listed conduit connector must be provided at each end of the power supply cable (at the range and at the junction box). Wire sizes and connections must conform with the rating of the range.
  • Page 6: Installation Instructions

    On ranges equipped with a warming drawer, the rear legs cannot be accessed by removing the warming drawer. It will be necessary to adjust the rear legs from outside the range. Use wrench or pliers to lower the front and rear leveling legs one-half turn.
  • Page 7: Electrical Connection - U.s.a. Only

    1. Disconnect power. 2. Remove the terminal block cover screws located on the back of the range. Pull cover down and toward you to remove cover from range. A. Two mounting tabs each side B. Terminal block cover C.
  • Page 8 1. Part of metal ground strap must be cut out and removed. 2. Use a Phillips screwdriver to remove the ground-link screw from the back of the range. Save the ground-link screw and the end of the ground-link under the screw.
  • Page 9 C. UL listed strain relief D. Power supply cord wires 4. Use a Phillips screwdriver to connect the green ground wire from the power supply cord to the range with the ground-link screw and ground-link section. The ground wire must be attached first.
  • Page 10 Save the ground-link screw and the end of the ground-link under the screw. 3. Pull the wires through the strain relief on bottom of range. Allow enough slack to easily attach wiring to the terminal block.
  • Page 11 Use this method only if local codes permit connecting ground conductor to neutral supply wire. 1. Pull the wires through the conduit on cord/conduit plate on bottom of range. Allow enough slack to easily attach the wiring to the terminal block. A. Terminal block D.
  • Page 12: Verify Anti-Tip Bracket Location

    2. Place level on rack and check levelness of range, first side to side; then front to back. 3. If range is not level, pull range forward until rear leveling leg is removed from the anti-tip bracket. On Ranges Equipped with Storage Drawers: Use a ¼"...
  • Page 13: Complete Installation

    Range is plugged into an outlet. Electrical supply is connected. See “Troubleshooting” in the Use and Care Guide. When the range has been on for 5 minutes, check for heat. If range is cold, turn off the range and contact a qualified technician.
  • Page 14: Moving The Range

    WARNING Tip Over Hazard A child or adult can tip the range and be killed. Connect anti-tip bracket to rear range foot. Reconnect the anti-tip bracket, if the range is moved. Failure to follow these instructions can result in death or serious burns to children and adults.
  • Page 15: Anti-Tip Bracket Template

    ANTI-TIP BRACKET TEMPLATE Cut on dotted lines and place the left edge against the left side cabinet and the top edge against the rear wall. Top edge...
  • Page 16 W10252706B © 2009. 9/09 All rights reserved. Printed in U.S.A.

Table of Contents