Gas Regulator; Sealed Burner Base And Spark Ignitor; Drip Pan; Orifice Holder And Venturi Tube - Maytag RJRD3010 Series Service Manual

Disassembly Procedures
!
WARNING

Gas Regulator

1. Turn off gas and power supply to the cooktop.
2. Disconnect all gas lines from gas regulator.
3. Replace component and reverse procedure to
reassemble.
NOTE: When installing, use pipe dope compound.
Perform gas leak test to ensure unit will not leak
and cooktop operates properly.

Sealed Burner Base and Spark Ignitor

1. Remove burner grates and burner caps from cooktop.
2. Remove screws securing burner base to burner orifice
holder.
3. Raise sealed burner tops and disconnect wire
terminals from spark ignitors. Remove by lifting burner
base off drip pan.
4. Replace component and reverse procedure to
reassemble.

Drip Pan

1. Remove burner base(s), see "Sealed Burner Base and
Spark Ignitor" procedure, steps 1 through 3.
2. Lift drip pan upward to remove from unit.
3. Replace component and reverse procedure to
reassemble.

Orifice Holder and Venturi Tube

1. Remove burner base(s), see "Sealed Burner Base and
Spark Ignitor" procedure, steps 1 through 3.
2. Lift drip pan upward to remove from unit.
3. Release control panel cover, see "Control Panel"
procedure, steps 1 through 6.
4. Disconnect venturi tube from burner valve.
5. Remove screws securing burner support bracket to
burner box.
6. Remove burner support bracket and burner
assemblies from burner box.
7. Remove screws securing burner assembly to burner
support bracket.
8. Replace component and reverse procedure to
reassemble.
NOTE: When reassembling unit, connect venturi tubes
to the burner valves before securing burner
support bracket.
© 2005 Maytag Services
To avoid the risk of electrical shock, personal injury or
death; disconnect power to range and shut off gas
supply before following any disassembly procedure.
Oven Door
Removal
1. Open oven door completely.
2. Located on door hinge, move hinge locking arm
upward to release.
3. Raise oven door to stopping position.
4. Grasp oven door on outside edges and raise oven
door upward and pull outward to release from hinge
receptacle.
5. Reverse procedure to reassemble.
Disassembly Outer Door Assembly
1. Remove oven door, see "Removal" procedure above.
2. Place oven door on a padded surface.
3. Remove screws securing outer door to inner oven
door, screws located on top and bottom.
4. Separate outer door from inner door, by pulling the
two pieces apart.
5. To remove oven door handle, remove nuts securing
door handle to outer door, located at the top of the
outer door.
6. Remove door handle from oven door.
7. Remove screws securing bottom portion of side
retainers.
8. Remove inner door glass from outer door assembly.
9. Remove side retainers from outer door assemble and
remove metal tube spacers from assembly.
10. Remove outer door glass from outer door.
11. Remove old two sided tape from outer door.
12. Replace component and reverse procedure to
reassemble.

Disassembly Inner Door Assembly

1. Remove oven door, see "Removal" procedure above.
2. Place oven door on a padded surface.
3. Remove screws securing outer door to inner oven
door, screws located on top and bottom.
4. Separate outer door from inner door, by pulling the
two pieces apart.
5. Remove screws securing inner door retainer to inner
door and remove inner door retainer from assembly.
6. Remove insulation from around inner door glass
assembly.
7. Remove inner door glass assembly from inner door.
8. Replace component and reverse procedure to
reassemble.
16026509 19