Chapter 5. Set-Up And Operation; Setting Up The Dvp And Ela - Woodward ELA 150 Installation And Operation Manual

Manual 35183
DVP10000
Instructions
Manual 26912
For additional instructions and information regarding the DVP Service Tool, refer to manual 26912
Woodward
Released
Chapter 5.
Set-up and Operation

Setting up the DVP and ELA

To prevent damage to electronic components caused by improper
handling, read and observe the precautions in Woodward manual
82715, Guide for Handling and Protection of Electronic Controls,
Printed Circuit Boards, and Modules.
During set-up and verification, it is critical that the prime mover be
shut down and secured. Do not perform set-up or verification on a
machine which is not properly locked out.
Abide by all local codes and plant safety procedures regarding
instrument verification and check-out prior to operation on the
machine.
Refer to DVP10000 manual 26773 for critical installation instructions
and warnings that may pertain to its EMC or Hazardous Locations
certifications. The following instructions are specific to this actuator
only and are meant as a supplement to the general DVP10000
instructions. Failure to do so may result in poor performance,
personal injury, or death.
Before you begin, install the DVP Service Tool on a laptop or desktop
computer. THE DVP SERVICE TOOL MUST BE INSTALLED TO
CONFIGURE THE DVP DRIVER.
Electric Linear Actuator (ELA) 150 Base Mount
27