Table of Contents
Advertisement
100304 - 22-kW HOME STANDBY GENERATOR WITH AXIS CONTROLLER
No AC output
1
Circuit breaker in "OFF" position
2
Main circuit breaker in "OFF" position.
3
Transfer switch breaker in "OFF" position.
4
Standby breakers set in "OFF" position.
5
Line circuit tripping breaker because of short circuit *
6
Line circuit tripping breaker because of overload *
7
Poor wiring connections*
8
ATS problems*
Reset fault code(s)
There is an exterior warning LED located on the back of the enclosure. This should be checked weekly to make sure there are no active
fault codes.
Maintenance
The maintenance hour meter counts from 100 hours to 0.
1
You need to reset when the hour meter reaches 0.
BATTERY(S) NO OR LOW LEVEL CHARGED, BATTERY(S) DEAD, NEEDS REPLACEMENT, THE EXERCISE TIME MUST BE RESET ONCE
THE BATTERY(S) HAVE BEEN DISCONNECTED.
* *Contact Champion Power Equipment, Technical Service toll free 1-877-338-0999, tech@championpowerequipment.com or your nearest Champion dealer.
www.championpowerequipment.com
®
Turn on breaker.
Turn on breaker.
Turn on breaker.
Turn on breaker.
Refer to "Resetting the maintenance hour meter" for instructions after
performing maintenance.
36
MAINTENANCE
Advertisement
Table of Contents
