Table of Contents
Advertisement
100304 - 22-kW HOME STANDBY GENERATOR WITH AXIS CONTROLLER
fCC Statement
* Applicable in USA only.
1. This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions:
1a. This device may not cause harmful interference.
1b. This device must accept any interference received,
including interference that may cause undesired
operation.
2. Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications.
Industry Canada: CAN ICES-002/NMB-002
* Applicable in Canada only.
This device complies with Industry Canada license - exempt RSS
standard(s).
Operation is subject to the following two conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including
interference that may cause undesired operation of the
device.
Industry Canada: CAN ICES-003/NMB-003
* Applicable in Canada only.
This device complies with Industry Canada license - exempt RSS
standard(s).
Operation is subject to the following two conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including
interference that may cause undesired operation of the
device.
NOTICE
®
aXis Controller
®
The aXis Controller
is equipped to provide monitoring and
®
protection for the HSB.
AUTO
MAN
This button allows verification that the HSB power delivery
circuit is functional. The engine will start in manual mode.
Safety procedures should be followed. Prior to placing the aXis
Controller
in the "MAN" mode, the UTILITY, ATS active and LOAD
®
Icon will be lit.
AUTO
This button allows automatic delivery of power from the HSB when
there is a utility power outage. With the controller in the AUTO
position and the HSB not running (standby mode), the UTILITY,
ATS active and LOAD icon will be lit (view left to right), this
indicates the household is using Utility power. AUTO position is the
standby ready position. The aXis Controller
mode in order to exercise.
OFF
This button closes and shuts down the engine signals. It prevents
the automatic operation of the generator. OFF is required when all
maintenance or service are being performed on or around the unit.
MODE
This button allows user to cycle through screens of the aXis
Controller
.
®
Cycles through available menus in run mode:
–
DCV (first screen) – indicates current battery voltage
–
HZ – indicates alternator frequency
–
ACV – indicates alternator voltage
–
HR – indicates total run hours on Home Standby
Check button is used when programming the aXis Controller
18
GENERAL INfORMATION
OFF
ARRÊT
MAN
MODE
must be in the AUTO
®
MAN
.
®
Advertisement
Table of Contents
