Watchguard Firebox X1000 User Manual page 231

4
If the WSEP application was running, restart it after
saving the changes.
As a service, using the Command Prompt
If the WSEP application was not installed by the Watch-
Guard Firebox System installation wizard, this must be
done from the Command Prompt DOS window.
1 Select Start => Run and type: command .
A Command prompt window appears.
2
Change directories to the WatchGuard installation
directory.
The default installation directory is C:\Program
Files\WatchGuard.
3 At the command line, type:
controld -nt-install
You can perform other commands for the WSEP applica-
tion from the Command Prompt:
• To start the WSEP application, at the command line,
type:
- controld -nt-start
• To stop the WSEP application, at the command line,
type:
- controld -nt-stop
• To remove the WSEP application, at the command line,
type:
- controld -nt-remove
Interactive mode from a Command Prompt
The WSEP application can also run in interactive mode
from a Command Prompt window. To so this, type: con-
trold –NT –interactive
You can minimize the Command Prompt window. However,
not
do
the WSEP application.
User Guide
Setting up the WatchGuard Security Event Processor
N
OTE
close it. Closing the Command Prompt window halts
209