Connecting The Two Frames - Proactive Protekt Akra PMSEBHR User Manual & Entrapment Manual

Connecting the Two Frames

Head
Section
Figure 2
Connecting the Two Frames:
1. Place the Head Spring Section on its side to your left with the center
mounting shaft to the right. (See figure 1)
2. Place the Foot Spring Section on its side to your right with the head frame pull
tube at the top of the assembly and the center mounting input shaft facing to
the left and remove locking pin from both sides. (See figure 2)
3. The crank handles and/or motors should be at your right.
4. The head and foot springs should now be on their sides at approximately a
90° angle to one another.
5. Place the head spring center mounting shaft to the foot spring center
mounting input. (See figures 2 and 3)
6
Figure 1
Figure 3
User Manual & Entrapment Guide
Foot
Section