Related Manuals for Proactive Protekt Aire 2000
Summary of Contents for Proactive Protekt Aire 2000
- Page 1 Operation Manual Protekt Aire 2000 270 Washington Street, Mount Vernon, New York 10553 Phone# 1-855-BE-PROACTIVE (855-237-7622) Fax# 845-205-6005 www.proactivemedical.com...
-
Page 2: Table Of Contents
TABLE OF CONTENTS IMPORTANT SAFEGUARDS ......................3 STATEMENTS & SYMBOLS ......................4 INTRODUCTION .......................... 4 PRODUCT FUNCTIONS ....................... 5 CONTROL UNIT ........................... 5 OVERLAY ............................ 5 ENTRAPMENT GUIDLINES ......................5 INSTALLATION INSTRUCTIONS ....................6 OPERATING INSTRUCTIONS ....................... 7 CLEANING ..........................8 MAINTENANCE.......................... -
Page 3: Important Safeguards
IMPORTANT SAFEGUARDS When using electrical products, especially when children are present, basic safety precautions should always be followed, including the following READ ALL INSTRUCTIONS BEFORE USING DANGER To reduce the risk of electrocution: • Always unplug this product immediately after use. •... -
Page 4: Statements & Symbols
STATEMENTS & SYMBOLS Note, caution, warning & danger statements NOTE Indicates some tips or some information users should be aware of. CAUTION Indicates correct operating or maintenance procedure in order to prevent damage to or destruction of the equipment or other property. WARNING/DANGER Calls attention to a potential danger that requires correct procedures or practices in order to prevent personal injury. -
Page 5: Product Functions
Please refer to the specifications section for details. ENTRAPMENT GUIDELINES The use of Bed Rails is dependent on the setting as well as the facilities protocols. Proactive Medical does not make product recommendations for any given patient. Those decisions are the responsibility of the health care facility and/or health care professional(s) familiar with each patient’s unique requirements. -
Page 6: Installation Instructions
INSTALLATION INSTRUCTIONS Step 1 Place the overlay flat on mattress that is already on the bed frame. The inflation tube should be towards the foot end so that it can be connected to the inflation nozzles on the control unit. Secure the overlay in place. -
Page 7: Operating Instructions
OPERATING INSTRUCTIONS Step 1 Turn on the control unit power. The indicator of the power switch will come on. The control unit will start to blow air into the overlay. Step 2 The Low Pressure indicator (orange) will come on as inflation is underway. Step 3 Press the Static button for a quicker inflation. -
Page 8: Cleaning
CLEANING GUIDELINES • Use a neutral detergent to clean surface of control unit and overlay; disinfectant products may be used according to the manufacturer’s protocol. Do not use phenolics on this product. • Do not immerse the control unit in water. •... -
Page 9: Maintenance Trouble Shoot
MAINTENANCE TROUBLE SHOOT / TECHNICAL SPECIFICATIONS Trouble Signal Failure Cause Fault Handling The inflation tube is not con- Connect the air tube. nected to the control unit. Power indicator is ON. The silicone tubes inside the No air output Contact Service Personnel. control unit are disconnected. - Page 10 The warranty does not extend to non-durable components, such as rubber accessories, casters, and grips, which are subject to normal wear and need periodic replacement. If you have any questions about your Proactive Medical device or this warranty, please contact an authorized Proactive Medical dealer.