Table of Contents
Advertisement
Hand Crank for the Semi-
The manual bed crank is located at the foot of the bed.
1. Before attempting to manually adjust the bed height, it is necessary to remove
the optional height adjustment lock pins from each leg.
2. To raise the bed – Turn the crank handle clockwise.
3. To lower the bed – Turn the crank handle counter-clockwise.
If using the semi-electric bed footboard with a full-electric bed/motor, first
remove the crank handle from the footboard. If left in place, the crank will
turn when the motor is on and could cause personal injury or damage to
the bed.
The Trendelenberg Position
A position in which the head is low and the body and legs are on an inclined
plane.
Trendelenberg
1. Lower the bed to its lowest height. Disengage the drive shaft by compressing
the spring fitting and removing the drive shaft from the Hi/Low Motor to the
headboard gearbox.
2. Raise the foot end of the bed using the hand pendant or crank. The head end
of the bed will remain in the low position.
Reverse Trendelenberg
1. Raise the bed to its highest height. Disengage the Hi/Lo drive shaft by
compressing the spring fitting and removing the drive shaft from the motor to
the foot end of the bed.
2. Lower the end of the bed using the hand pendant or crank. The head end of
the bed will remain in the high position.
16
Electric Bed
User Manual & Entrapment Guide
Advertisement
Table of Contents
