Related Parameters; Introduction; Programmable Software - Control Techniques UD51 User Manual

6

Related Parameters

6.1

Introduction

The parameters listed in this chapter are used for programming and
monitoring the UD51 when it is fitted in a drive. Refer to the Unidrive User
Guide for programming instructions.
Before attempting to adjust any parameters, refer to the Warnings and Notes
at the beginning of Chapter 4 electrical installation in the Unidrive User Guide.
WARNING
6.2

Programmable software

6.2.1 Key
Type of parameter
...select
...enable Make or allow a function to operate
Limitations of use
P
Range
Bi
Uni
Bit
Symbols
UD51 User Guide
Issue Number: 5
RO Read-only
RW Read-write
Select from two settings
Protected parameter; the parameter cannot be used as the
destination parameter for a programmable input.
Variable parameter having bipolar value range.
Variable parameter having unipolar value range.
Bit parameter
Default value
Range of values
www.controltechniques.com
19