Table of Contents
Advertisement
6EDL_SPI_LINK configuration dongle for 6EDL71x1 series
User guide
Specifications
2
Specifications
Input and output at normal operation
Input: 5 V DC (from USB 1.0 or 2.0)
•
Output: 3.3 V or 5 V from target board, SPI clock, and data
•
Control scheme
Debugger controller: XMC4200 series MCU with Segger J-Link firmware
•
6EDL71x1 SPI encoder: XMC1400 series MCU with Infineon 6EDL_SPI_LINK firmware
•
Protection features
Isolation interface
•
Maximum component temperature
In an ambient temperature of 30°C, the maximum allowed component temperatures are as follows:
Resistors: Less than 100°C
•
Ceramic capacitors, film capacitors, and electrolytic capacitors: Less than 100°C
•
MOSFET transistors and diodes: Less than 100°C
•
ICs: Less than 100°C
•
Dimensions of the evaluation board
Width: 1.81 inches/46.0 mm, length 0.55 inches/14.0 mm.
Note:
To operate this board, the firmware must be configured correctly for the specific motor being
driven. This requires motor parameters such as phase winding inductance and resistance to be
entered into the motor control GUI before flashing the firmware to the target board.
Attention:
The board should be tested only by qualified engineers and technicians.
User guide
5
V 1.0
2023-11-02
Advertisement
Table of Contents
