Table of Contents
Advertisement
6EDL_SPI_LINK configuration dongle for 6EDL71x1 series
User guide
Firmware update
6
Firmware update
This section describes how to update the XMC1402 firmware, which interfaces the PC software application with
the target 6EDL71x1 device.
Attention:
The J-Link firmware is factory-installed and cannot be updated by the end user. The J-Link
port should never be accessed by the end user!
To install a firmware update, first install the XMCFlasher tool from the
Note:
It is necessary to have Java installed on the PC to run this application.
Figure 35
XMC Flasher
After installing the XMC Flasher, with the USB cable connected to the 6EDL_SPI_LINK adapter, open the
1.
XMC™ Flasher and click Connect as shown in
Figure 36
Connecting the XMC™ Flasher to the 6EDL_SPI_LINK
2. Select the XMC1402-0032 from the Select Device Name to connect and click Ok:
User guide
Infineon Developer Center
Figure
36.
20
Launcher.
V 1.0
2023-11-02
Advertisement
Table of Contents
