Table of Contents
Advertisement
Araknis Networks® 310 Series Router
User Interface Manual
Bandwidth Control Settings
This menu is used to configure the total bandwidth being limited among specific clients.
Note – Bandwidth Control does not guarantee any minimum amount of bandwidth.
•
Bandwidth Control Settings
• Interface – Select the WAN interface the rule will affect.
• Service – Select a service from the drop down. Use the All Traffic setting unless you want to regulate
bandwidth for a specific program or service using a forwarded port.
• IP Range – Set the range of IP addresses that will be affected by the rule. Enter the same address in
both fields to create a rule for a single IP address.
• Direction – Select whether the rule affects upstream or downstream traffic.
• Bandwidth (kbits/s) – Enter the minimum and maximum bandwidth allowance for the rule.
• Bandwidth Sharing – Select Sharing total bandwidth for all IP to split the specified bandwidth among
the clients, or Assign for each IP to allow the full specified bandwidth for each IP.
• Enable – Select whether the rule is in effect or not.
• Trashcan – Delete a rule.
• Add Bandwidth Settings – Click to add a new rule entry.
You must click Apply at the bottom right of the page to save changes.
-Return to Table of Contents-
56
Bandwidth Control Menu Overview
Advertisement
Table of Contents
