Table of Contents
Advertisement
Araknis Networks® 310 Series Router
User Interface Manual
Settings > LAN
Note – LAN4 has some communication limitations with LAN1–3, usually with discovery protocols.
If you are using the router-on-a stick topology, use LAN4 to connect your router to your master
switch. If you are using multiple ports on the router, use LAN1–3; reserve LAN4 for uses that do
not communicate with other LAN ports.
LAN Settings Section
Names can be up to 63 characters long, and can contain letters, numbers, hyphens, underscores, commas,
periods, and the following special characters: ! @ # $ % ^ & * ? +. It cannot contain spaces.
This shows the LANs available, their speed (color coded), and their duplex settings. Each port is color-
coded based on its negotiated speed:
• Gray: Not connected to a device, or the connected device has not negotiated a speed.
• Orange: 10/100Mbps connection is active.
• Green: 1Gbps connection is active.
• Red: Port has been disabled by the user in the web interface settings.
LAN4 can also be used as a third WAN port. To do so, click
on LAN4 and use the toggle to Enable WAN Mode. This
will remove LAN4 from your LAN settings page and show
WAN3 on your WAN Settings page.
To change WAN3 back to LAN4, click on WAN3 in the
WAN Settings and use the toggle to Enable LAN Mode.
-Return to Table of Contents-
Click on a port to open a dialog where you can change the
LAN's name, speed settings, and duplex setting (if the port
is not set to auto). This also shows the actual speed at
bottom, color coded as normal.
24
Settings > LAN
Advertisement
Table of Contents
