FLIR 310 Series User Interface Manual page 51

Araknis Networks® 310 Series Router
User Interface Manual
Adding a New Access Control Rule
1. Click Add ACL to open above window.
2. Set the desired Action, Service, and Log settings using the drop-downs.
3. Select the Incoming and Outgoing Interface, of the traffic to control, from the drop-down.
4. Enter a Source IP address, IP range, or MAC address the traffic will come from.
5. Enter a Destination IP address or range the traffic will be traveling toward.
6. Set up scheduling for when the rule will be active. If the rule needs to be active at all times, leave Time
set to Always.
7. Click Apply to enable the newly created rule.
-Return to Table of Contents-
• Enable – Check the box to enable the rule.
• Name – Enter a name to identify the rule.
• Priority – Select the priority of the rule from the drop-
down. The rules are enforced in order: Priority 1 takes
precedence over all other rules (2, 3, 4...).
• Action – Displays whether the rule is set to permit or
deny traffic.
• Service – Describes the traffic and ports enforced by
the rule.
• Log packets that match this rule – Enable to record
activity in the system log.
• Incoming Interface – Select LAN or WAN port from the
drop-down.
• Outgoing Interface – Select LAN or WAN port from
the drop-down.
• Source – Single IP, IP Range, or MAC address.
• Destination – Single IP or IP Range.
• Scheduling – Describes when the rule is in effect.
• Add – Click to add a new Access Control Rule.
51
Advanced > ACLs