Table of Contents
Advertisement
2.6 I Removing the cleaner from the water
•
Using the pole, you can remove the cleaner during the cycle and the cleaner will stop automatically
once it is out of the water.
•
At the end of a cycle, the cleaner always stops at the foot of a side.
2.6.1 Without the iAquaLink™ app
During the last ten minutes of the cycle, the cleaner will successively climb the various sides and wait at the waterline
until it is recovered using the handle (not available in the "Floor only" mode).
If it is not retrieved at this time, the cleaner at the foot of
a side at the end of the cycle
Catch the cleaner handle with the hook and raise the
cleaner to the surface
14
Attach the hook (supplied) to the end of a pool
pole (not supplied)
Use the handle to take it out of the water. The
cleaner expels water through a rear jet to make it
lighter
Advertisement
Table of Contents
