4.6 I Replacing the brushes
Are the brushes worn?
• Replace the brushes if the wear indicators are similar to example
Remove the worn brushes
• When the cleaner is not placed on the base, remove the tabs from the holes in which they are fastened, then remove
the brushes.
Position the new brushes.
• Fit the side without tabs under the brush holder (see figure
• Roll the brush around its support, slide the tabs into the attachment holes and pull on the end of each tab until its
edge passes through the slit (see figure
• Cut the tabs using a pair of scissors for them to be level with the other blades (see figure
:
).
).
EN
).
21