Removing The Cleaner From Pool - Zodiac V1 Owner's Manual

ON/OFF
Button
Figure 6. Start the cleaner.
4. After the cool down period is complete, the green
indicator will turn off. The unit can be removed
from the pool.
NOTE The Zodiac V1 includes a safety feature that
automatically stops the cleaner if it is powered
ON when it is not submerged in the water. For
pools equipped with a beach area, this safety
feature allows the cleaner to reverse, and go
back into the pool.

4.3 Removing the cleaner from Pool

1. Remove the Zodiac V1 from the pool after the
cleaning cycle is completed.
cAUTION
To prevent damage to the cleaner, never lift the
Zodiac V1 robotic cleaner out of the pool using the
floating cable.
Remove the Zodiac V1 from pool when super
chlorinating.
Do not handle cleaner while it is in operation.
2. Never lift the Zodiac V1 out of the pool by the
floating cable. Always use the handle to remove
it from the pool. Drain the remaining water from
the cleaner by keeping the cleaner in a vertical
position. Refer to Figures 7 and 8.
3. Disconnect the control unit cable from the
electrical outlet.
4. Disconnect the cable from the control unit.
5. At the end of each cycle, coil the cable starting at
the cleaner and go toward the connection point at
control unit. Remove coils or twists along the way.
6. Store cleaner out of direct sunlight.
Figure 7. Remove cleaner From Pool
Figure 8. keep cleaner vertical to Drain Water
IMPORTANT
• Use your Zodiac V1 robotic cleaner as often as
needed to keep your pool clean.
• Clean the filter canister after each cleaning cycle.
• Do not leave your cleaner in the pool on a
permanent basis.
• At the end of each cycle, remove the cleaner from
the pool. Start at the cleaner head and untangle any
coils in the hose before storing the cleaner.
Page 7