I Removing The Cleaner From The Water - Zodiac Vortex GV 33 Series Installation And User Manual

2.8 I Removing the cleaner from the water

• To prevent damaging the equipment, use only the handle to remove the appliance from the
pool.
2.8.1 "LIFT SYSTEM" automated mode
The "Lift System" function was designed to facilitate removing the cleaner from the water. It may be activated at any
time, during or at the end of a cleaning cycle.
• If necessary, press and hold the button
When facing the right wall, release the button. The cleaner moves towards the wall (see image
• Or just briefly press the button
• The cleaner climbs the wall and stays at the waterline (see image
• Use the handle to take it out of the water. The cleaner expels water through a rear jet to make it lighter (see
).
image
2.8.2 Manually
• Switch off the appliance by pressing
• Bring the cleaner to the edge of the pool by gently pulling on the floating cable.
• When possible, pick up the cleaner by the handle and lift it gently out of the pool so that the water it contains drains
into the pool (see image
15
to direct the cleaner towards the required wall, the cleaner pivots.
to move it towards the opposite wall (see image
.
).
and
).
).
01'30''
).