Table of Contents
Advertisement
3.2
Starting the Cleaner
The first time you use the cleaner, the cleaning surface
setting is Floor and Wall
After the first time, the default is the last setting used.
Select Cleaning Surface:
• Use
to change cleaning surface setting.
Begin Cleaning:
•
After selecting the cleaning surface,
press
to begin operation.
•
At the beginning of the cycle, the cleaner
remains in place for a few seconds to initialize
the microcontroller after the fan motor starts.
3.3
Wall Climbing
(Surface Control System)
The cleaner has the ability to clean the pool walls up to
the waterline. How much the cleaner needs to grip to the
wall depends upon the pool surface.
Grip Intensity Indicator:
Surface Control System (SCS) settings are as follows
for different pool surface types:
1 Pebble Surface (ROUGH)
2 Concrete
3 Vinyl / Fiberglass
4 Tile (SMOOTH)
Check Wall Climbing Setting:
•
Start the cleaner and watch as the cleaner
climbs each wall. If grip setting is correct, the
cleaner will easily climb the wall and clean up
to the waterline. The default setting is
NOTE: Wall climbing is programmed in a randomized
(SMOOTH) pattern. Cleaner may climb wall and not
reach waterline until third or fourth attempt in order
to thoroughly clean wall surface below the waterline
first.
•
Adjust the wall climbing setting as necessary
using the following guidelines:
Increase:
slowly and stays below the waterline.
Decrease: if cleaner is climbing the wall too
quickly and sucking air at the waterline.
Adjust SCS Wall Climbing Setting:
You can change the wall climbing setting at any
time during cleaner operation with the SCS button.
The new setting will be active when the cleaner
climbs the next wall.
•
Press
one level higher.
•
One additional LED lights each time you press
the button to indicate stronger grip on the wall.
•
To decrease setting, press button to cycle
through back to one LED (lowest setting).
_
1
2
3
+
4
3.4
Stopping the Cleaner
and Removing from the Pool
1.
Press
2.
When the cleaner is within arm's reach, use the
handle to lift it from the water (Figure 5).
Never lift the cleaner out of the pool by the
floating cable.
:
Figure 5.
Lift Cleaner From Pool with Handle
H0446500_REV A
if cleaner is climbing the wall
to adjust the wall climbing setting
_
1
2
3
+
4
to interrupt operation.
2
1
7
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
