I User Alerts - Zodiac FREERIDER RF 5200 iQ Installation And User Manual

5.3 I User alerts

• The indicators on the rear of the cleaner blink to report an alert to the user. Find which indicator is blinking and apply
the suggested troubleshooting solutions.
• User are also accessible from the iAquaLink™ app.
Clearing an error code from the iAquaLink™ app:
• After following the troubleshooting solutions, press Clear Error.
5.3.1 Cleaner error
"On/
Blinking red
off"
If the problem continues contact your retailer:
•
If the cleaner stops before the end of its cycle but no indicator is blinking when it is removed from the
water, place the cleaner on its charging station so that the indicator will start to blink
Display in the
iAquaLink™ app
Safety Shut-off
• The cleaner is in safe state.
• The cleaner board is under power but
Communication does not respond.
Contact your retailer
error
Traction motor right
• Check that debris is not preventing the
brushes or tracks from moving freely.
Traction motor left
• Rotate each wheel by a quarter of a turn
in the same direction until it rotates
Drive motor
smoothly. Repeat turning wheels in
the opposite direction until rotation is
consumption right
smooth.
• If this fails to solve the problem, contact
Drive motor
your retailer for a full diagnosis.
consumption left
• Clean the filter thoroughly.
• Put it back in the water, shaking to
Cleaner out of the
release the air bubbles.
• Restart the cycle.
water
• If this fails to solve the problem, contact
your retailer for a full diagnosis.
• Be careful to force the appliance to
stop before cleaning the propeller:
when the cleaner is not placed on the
charging station, hold the cursor to the
left until all the indicators go out (about
20 secondes). Check that the cleaner
is completely off by moving the cursor
Pump motor
: no indicator should light up. Then,
check that no debris or hair is blocking
the propeller. Cleaning must take place
out of the water and the cleaner must
be placed on a dry surface.
• Clean the filter thoroughly.
• If this fails to solve the problem, contact
your retailer for a full diagnosis.
• Close the iAquaLink™ app.
• Check that the cleaner is connected to
the Wi-Fi network (the blue LED is on
Firmware Update
and steady).
Error
• If the indicator is not steady, open the
iAquaLink™ app, select the cleaner and
click on "Update".
Solutions
.
EN
25