Trimming The Outboard Motor - TOHATSU BFT 80A Owner's Manual

OPERATION

Trimming the Outboard Motor

68°
TILT
ANGLE
16°
0°
TRIM ANGLE (VERTICAL LINE)
(when transom angle is 12°)
The BFT75A/80A/90A/100A T types
are equipped with the power trim/tilt
system which can adjust the outboard
motor angle (trim/tilt angle) while
cruising and mooring. The outboard
motor angle can also be adjusted
while cruising and accelerating to
obtain the maximum speed and
optimum driveability and fuel
economy.
108
(H1 type)
POWER TRIM/TILT SWITCH
Press UP to
raise bow.
12°
Press DN to
lower bow.
0°
- 4°
Press either UP or DN (down) of the
power trim/tilt switch and tilt the
outboard motor to the best position in
compliance with the cruising
conditions.
(H2 type)
Press DN to
lower bow.
Press UP to
raise bow.
POWER TRIM/TILT SWITCH
The power trim/tilt system operates
when the switch is pressed, and it
stops when the switch is released.
To trim up slightly, press on UP
momentarily but securely.
To trim down slightly, press on DN
(down) in the same manner.