TOHATSU BFT 80A Owner's Manual page 149

WATER LEVEL
POSITIONING
SENSOR 2 PIN
BAND
CONNECTOR
HARNESS CLIP
POSITIONING
CLIP C
BAND
HARNESS
9. Connect the water level sensor 2
pin connector. Install the harness to
the clip C and harness clip.
Align the positioning bands on the
harness with the end of the clip C
and harness clip as shown above.
10. Reinstall the water separator in
the reverse order of removal.
11. Prime the engine using the
priming bulb (see page 76). Check
for fuel leaks.
Repair any fuel leaks if necessary.
If the buzzer sounds, water or
sediment accumulation is found to be
caused by excessive water or
sediment accumulated in the water
separator cup, inspect the fuel tank.
Clean the fuel tank if necessary.
MAINTENANCE
147