Machine Operation; Tank Emptying - Viper AS430C-US User Manual

CONSULTATION
Each safety
independently the operation of the brush. In use,
facilitates the control of the operation of the machine.
Operators are encouraged to find the most comfortable
position their hands.
Turning off the machine
7. When you have finished using the machine, first remove the
brush/pad-holder (refer to the steps mentioned above)
8. Release the safety switch (1) to turn off the brush/pad-
holder and solenoid valve.
9. Press the Vacuum switch (39) to the "Off" position, and the
Vacuum will delay for 5 seconds before stopping work.
10. Press the solution control switch (40) to the "Off" position
to completely turn off the solution flow.
11. Press the power switch (38) to the "Off" position. And
disconnecting the power cable (9) from the power supply.
12. Use the squeegee lift handle (14) to lift the squeegee.
13. Grasp the handle (2) and gently tilt the machine backward
until the guide wheel (B) touches the floor. See Figure7.

MACHINE OPERATION

1. Start the machine according to the description above.
2. Hold the on / off switch (1) (Figure 6), push to move the machine, and start the scrubbing.
3. If necessary, turn off the machine, and adjust the squeegee. (Refer to the steps for squeegee
adjustment)
4. If necessary, turn off the machine, and adjust the solution flow with the ball valve handle. (Refer
to the steps for adjusting solution flow.
CAUTION
！ ！ ！ ！
In order to avoid damaging the floor, when the machine stays in one place without
moving, remove hands from switches & turn off the main power switch (38).

TANK EMPTYING

When recovery tank is full, a float shut-off device (36) will block the inlet connecting to the vacuum
motor. Through a sudden increase of noise from the vacuum motor, it can be considered that the
recovery tank is full and requires immediate draining.
CAUTION ！ ！ ！ ！
If the vacuum motor is suddenly turned off (due to sudden movement
resulting in an activation of the float), and if a resumption of operation is
needed, please perform the following steps: press the power switch (38 and
39) to turn off the power and the vacuum motor, and open the recovery tank
cover (25) to check if the float has returned to the water surface. Close the
recovery tank cover (25), and press the power switch (38 and 39) to turn on
the main power and the vacuum motor.
Recovery tank emptying
1. Turn off the machine.
2. Raise the squeegee assembly (14).
3. Move the machine to a dedicated draining location.
4. Grasp the handle (2) and tilt the machine backward until the guide wheel touches the floor.
5. Remove the drain hose from the clip, bend the top end of draining hose (A, Figure 8), and then
remove the drain hose cap. Lower the hose to a low level or on the ground to drain the water.
Alternatively, place drain hose to a low position or on the ground to make the water outlet face
： ： ： ：
switch is capable of controlling
it
7
USER MANUAL
Figure 6
Figure 7