Advertisement
* Read operators manual thoroughly prior to
operating or servicing this machine.
GENERAL USE
1] Remove any obstructions
obstacles in the area which is to be cleaned.
2] Place the handle in the upright position and
tilt machine back until handle rests on the
floor.
l
Be sure the machine is not plugged
into an outlet.
3] Attach the pad driver or brush to the machine
by placing the clutch plate over the gearbox
hub and turning the driver / brush 1/4 turn.
4] Place machine back into its upright position.
5] Plug power cord into grounded outlet.
* Never use an extension cord in
conjunction with the standard power cord.
6] The handle height may be adjusted by
lifting up on the handle release lever,
located on the right side of the switch
housing. Pull trigger and lower handle to
desired
operating
trigger to lock the handle into position.
7] To start the machine, press the red safety
button on the top of the upper switch
housing, and then squeeze either of the
operating triggers. [the safety button must
be depressed prior to squeezing the
operating triggers].
8] When the machine is in operation, both
hands should be placed on
housing [upper handle].
9] During operation, to make the machine go
right, gently raise the handle. To make the
machine to left, gently lower the handle.
10] To stop the machine at any time, simply
release the operating trigger [s] and the machine
will stop automatically.
Operation of Floor Machine
or
position.
Release
the switch
To keep the machine performing well for many
years, please follow the following maintenance
other
procedures.
* Always confirm that the machine is
unplugged
maintenance or repairs.
1] Unplug machine as soon as you are done
using it.
2] Tilt machine back and remove pad driver or
brush.
*Never store a low speed machine with the
pad driver or brush mounted to the
machine
3] Clean the outside of the machine with a mild
cleaner.
4] Check power cord for any damage. If
damage is detected, replace the cord
immediately.
5] Lubricate wheels with a water resistant
lubricant once a month.
6] Check machine for loose or missing nuts and
bolts, and replace as necessary.
7] If the machine is used in a dusty environment,
you may remove the motor cover and blow
the motor clean with compressed air. This
will ensure proper ventilation, and allow the
motor to run cooler.
1] Unplug machine from power source and wrap
cord on handle.
2] Tilt machine back and remove pad driver or
brush.
3] Store machine in upright position and in a dry
area.
4
MAINTENANCE
prior
to
performing
STORAGE
any
Advertisement
