Table of Contents
Advertisement
SCHEDULED MAINTENANCE TABLE
Clean squeegee
Clean brush/pad-holder
Clean water tank and float filter, inspect
tank gaskets
Inspect and change the squeegee blades
Clean solution filter
Clean vacuum motor filter
Inspect tightness of nuts and bolts
Inspect or change motor carbon brush of
brush motor
Inspect or change carbon brush of Vacuum motor
(1) It should be done 9 hours after the machine starts working.
(2) These maintenance procedures must be done by an authorized VIPER Service Center.
SQUEEGEE CLEANING
NOTE
In order to maintain the optimal squeegee performance, the squeegee must be
kept clean, and the squeegee blades must remain in good condition.
CAUTION
When cleaning the squeegee, it is recommended to put on protective gloves as
the squeegee may contain sharp debris
1.
Move the machine to a flat and smooth surface.
2.
Press the power switch (38) to the "
3.
Unscrew the squeegee knobs (16); remove the vacuum hose from the squeegee assembly &
remove squeegee.
4.
Use the squeegee lift handle (14) to lift the squeegee mount bracket.
5.
Using a damp towel, clean the squeegee (Figure 10). Clean in particular the groove (A, Figure
10) and the dirt and fragments on the vacuum tube. Check if the front squeegee blade (C) and
the rear squeegee blade (D) are intact, and if there are broken edges and cracks. Replace them
if necessary (refer to the steps in the following section).
6. Re-install the squeegee in the reverse order of the above
SQUEEGEE BLADE CHECK AND REPLACEMENT
1. Following the methods related in the previous section clean the squeegee (Figure 10)
2. Check the edge (E, Figure 10) of the front squeegee blade and the edge (F) of the rear squeegee
blade (D). On the whole length, they should be level. Otherwise, adjust their heights through the
following procedure.
Loosen the clip (G) to let the rear squeegee blade (D) separate from the bracket (M) for the
－
adjustment of the position of the squeegee. After the adjustment, lock the clip once again.
Loosen the screw on the handle (I) to adjust the front squeegee blade (C); tighten the handle
－
screw after adjustment.
3
Check if the front squeegee blade (C) and the rear squeegee blade (D) is intact and if there are
broken edges and cracks. If damage is found, change them according in the following way. If the
front edge of the rear squeegee blade (J) has worn, it can be flipped upside down and re-installed
(the top edge is required to be intact). If the top edge is also worn, change it by following the
procedure below:
Loosen the clip (G) to let the pressure blade separate from the bracket (M), take off the clip
－
bar (K), and then change or turn the rear squeegee blade (D) upside down. Re-install the rear
squeegee blade in the reverse order of taking it off.
Procedure
！ ！ ！ ！
" position to turn off the machine.
O
Daily,
Weekly
Machine
after use
.
9
USER MANUAL
Every
Annually
6 months
1
(
)
2
(
)
2
(
)
Advertisement
Table of Contents
